FWIW: booting fine in very stock Solus Budgie VM running on VMware ESXi 6.5 w/no fs encryption.

In T1319#171158, @DataDrake wrote:

@stalebrim Nope. They don't tag releases.

In T9362#178803, @JoshStrobl wrote:

I've enabled this as of 5.10-rc5

Thank you @YakoYakoYokuYoku for your reply. I've tried it out, trying to adapt the DroidCam instructions merged with your suggestions. (I personally need it to work with software that is also available on an iOS device...I think) So far I cannot get it to work. The pulse audio part works and creates the virtual microphone, however I cannot get it to attach to the virtual webcam using the gst-launch-1.0 example modified for my virtual cam.

Hi @JoshStrobl. I didn't specifically check the graphics drivers, however, I think you are right, that I had not rebooted this particular system. I generally always reboot after I run the upgrade for the Friday sync.

In T83#142343, @Girtablulu wrote:

thanks for the confirming and sorry for that mistake :)

In T83#142332, @Girtablulu wrote:

@SuperJC710e https://drive.google.com/open?id=1tmgnnJtPofndeDRWfacAXv5zlUE8T-s4 sane check and yea, I idiot had the wrong printer mentioned inside the path....

In T83#142210, @Girtablulu wrote:

Mmh will have to look deeper into it if I need to do something else

In T83#142207, @Girtablulu wrote:

well yea I did but I run something else wrong https://drive.google.com/open?id=1lwaDFICAdXBIlbZTMKnfjq13E07-etes

let's hope this works

In T83#142202, @Girtablulu wrote:

@SuperJC710e https://drive.google.com/open?id=1IEfBTdfLvGZWNN4Nik8_pHTZWsRn2jO5 for you as well, this one should be working now

In T83#142162, @Girtablulu wrote:

@SuperJC710e did some changes could you please try this? https://drive.google.com/open?id=11BHYHAYaBSYvGKbpnx-yKhFFiTho2bPy

In T83#142114, @Girtablulu wrote:

@SuperJC710e great at least it's printing, did you try as well as in increasing the dpi to 600 and did you check inside the printer settings if everything is set? Because you are the first who is reporting such an issue and as by far I can see and the package should work as all the others :/

@alexanderzhirov thanks for the checking, still looking into it, can you see your printer via lsusb ?

Thanks for the package! I installed it and the printer works without errors, however the printing is not a nice as from my Fedora system,

Thanks for the hard work on building these native drivers. I would like to make a request for our printer.